DIY Kits

21 Nov 2009

Support Center » Knowledgebase » DIY Kits

	DIY Kits

Solution How do I solder the solar cells I purchased together?

Apply flux to the white bus bar running the whole length of the cell about 1 inch from the end of the cell (the whole inch). Position your interconnection material (tabbing) directly on top of the flux you just applied covering the bus bar. Using your soldering iron, gather solder on the tip of the iron. Then apply the solder to the top of the interconnection material with a small swirl like motion until the solder spreads over the tabbing and cell. If the solder does not apply, hold the solder to the tabbing for 3-4 seconds. It should apply itself to the tabbing and cell.

Article Details

Article ID:

Created On:

06 Sep 2007 12:57 PM